Pay Now

MAGICRETE PUTTY PLUS

Putty Plus is a polymer modified white cement based wall putty specially developed as a finishing coat to cover the unevenness and pinholes created by plastering and to prepare the wall/ surface for painting.

It can also be treated as a base coat for painting.

Putty Plus adheres to ‘Housing Development Board of Singapore’ standards and is specially formulated using German make polymers to impart classy finish to walls and ease of work to applicators.

Putty Plus is available in Fine & Coarse variants.

PuttyPlus Features

75% EXTRA WATER RESISTANT*

8% EXTRA SMOOTH FINISH*

10% EXTRA WORKABILITY*

UV RESISTANCE

25% EXTRA STRONG BONDING*

11% EXTRA ECONOMICAL*

PuttyPlus Advantages

No requirement of primer

Protects expensive paint from flaking, dampening and peeling off

Reduces paint consumption

Superior paint finish

Technical Specifications

PARAMETERS SPECIFICATIONS
Appearance White Powder
Initial/Final Setting Time 270/300 Min
Tensile Adhesion Strength > 1.0 MPa in 28 days
Compressive Strength (MPa) 8.5 MPa in 28 days
Flexural Strength 2.1 MPa in 28 days
PARAMETERS SPECIFICATIONS
Water Retentivity 99.60%
Pot Life 90-100 Min
pH 9.2- 10.1
Coverage (1-1.5 mm coat) 12-15 Sq Ft/kg depending on wall finish

*Specifications may vary, due to continuous product development

PREPARATION & APPLICATION

SURFACE PREPARATION

The surface application should be free from loose particles, grease or any other foreign material. For uneven areas, re-plaster them with Magicplast-Gypsum Plaster or Magicplast-Readymix Plaster

PREPARATION

  • Mix 1kg of Putty Plus in 350-400 ml of water in clean bucket and not vice versa
  • Mix continuously by hand or using an electrical stirrer to obtain a homogenous lump-free paste
  • Leave the mix to slake for 10 minutes
  • Remix the paste for about 2 minutes before use
  • Use the mixture within 30 minutes of preparation

APPLICATION

  • Dampen the surface to be plastered with clean water
  • Use a steel trowel/blade to apply the mixture of about 0.5-1 mm thickness
  • Level and smoothen the surface and cure the first coat lightly once it dries
  • Apply the second coat of 0.5-1 mm thickness once the first coat is fully dried and set
  • The thickness of each coat should not exceed 1mm and the total thickness of plaster should not be more than 2 mm

DOWNLOAD

MAGICPLAST WALL PUTTY BROCHURE